MV Sealth
Template:Short description Template:Use mdy dates
| Script error: No such module "InfoboxImage". MV Sealth docked at Bainbridge Island Script error: No such module "Check for unknown parameters".
Script error: No such module "WPSHIPS utilities". Script error: No such module "WPSHIPS utilities". |
MV Sealth is a Script error: No such module "WPSHIPS utilities". operated by Washington State Ferries. She is named for Chief Sealth. The Sealth underwent cabin rebuilding in last 2006, after which she was in service on the Fauntleroy-Vashon-Southworth route. The Sealth was then the #2 vessel on the route. Earlier she was taken out of service due to a seam needing weld repairs.[1]
The Sealth was not listed to return to the San Juan Islands in late 2015. She was in service at Seattle/Bremerton and switched to the Vashon route mid-fall and she remained there until the Winter 2016 schedule began. She replaced the Script error: No such module "WPSHIPS utilities". as the inter-island ferry in the San Juans when it was retired. She is currently on the San Juan’s inter-island and San Juans Anacortes routes during low traffic times of day.
Incidents
On November 7, 2012, the Sealth was serving the Bremerton run when a hole four feet under the waterline at No. 2 end port side was discovered.[2] The ferry was pulled from service in the day and the leak was fixed a week later at Dakota Creek Shipyard of Anacortes. This caused the Script error: No such module "WPSHIPS utilities". to be put on the run, causing a loss of 30% percent of the run's regular car capacity.
In 1991, the Sealth collided with the Script error: No such module "WPSHIPS utilities". in Rich Passage in heavy fog. No major damage was reported.
References
<templatestyles src="Reflist/styles.css" />
- ↑ Route information - M/V Sealth, WSF, WSDOT
- ↑ Script error: No such module "citation/CS1".
Script error: No such module "Check for unknown parameters".