Ordnance QF 32-pounder

The Ordnance QF 32 pounder or (32-pdr) was a British 94 mm gun, initially developed as a replacement for the Ordnance QF 17-pdr anti-tank gun.

The only use of the 32-pounder was as the armament for the pilot vehicles of the Tortoise heavy assault tank.

Development

Development started in October 1942, due to a General Staff order for a successor to the 17-pdr gun. Basic requirements involved the new gun to be "at least 25% more effective" than the 17-pdr. Initial focus was on development of a 55-pdr gun, although advancements in 17-pdr ammunition meant the advantages that would be secured by the 55-pdr were no longer as desirable, while the 55-pdr would suffer from considerable disadvantages such as the difficulties in the handling and stowage of ammunition. Other options considered included a 76 mm (3-inch) 17-pdr firing a Armour Piercing Composite Rigid (APCR) shot at a muzzle velocity of a 3-inch tapered to 2.25-inch (76 to 57 mm) "squeeze bore" firing a Armour-Piercing, Composite Non-Rigid (APCNR) shot at and a calibre. Eventually, a 3.7-inch 30-pdr gun was proposed for a standard calibre, as it had a better margin for improvement. The QF 3.7-inch anti-aircraft gun was selected as the basis for the 30-pdr anti-tank gun in September 1943 and for pilots to be built.

During development, it was proposed that a shot would give better performance, and this new design was trialled as the QF 37 pdr EX1 in June 1944. Following firing trials, the 37 lb shot was dropped for a shot, and the gun was accepted as the QF 32-pdr.

At least one 32-pdr was developed as an anti-tank gun on a wheeled carriage and a single example using a novel form of muzzle brake was installed in a de Havilland Mosquito FB Mk. XVIII as an up-gunned version of the 'Tsetse', in place of the 57 mm 6-pounder Molins gun. While flight trials did not take place until after the war had ended, the aircraft flew and the gun fired without problems.

The 32-pdr fired a 32 lb (14.5 kg) armour-piercing shot at a muzzle velocity of and a Armour-piercing discarding sabot (APDS) shot at .

During firing trials on 28 June 1945, the 32-pdr Shot Mk.3 APDS shot penetrated of rolled homogeneous armour at 50° – a line of sight equivalent of - and on impact, which meant that its penetration surpassed those of the 17-pdr and 20-pdr APDS rounds, and could even rival early armour-piercing fin-stabilized discarding sabot (APFSDS) rounds in raw penetration. The 32-pdr gun could have easily penetrated the front hull of the Tiger II (Konigstiger) and Jagdtiger; it would have been the only allied anti-tank gun that could do so in the Second World War. By comparison the M308 HVAP shell of the 90 mm M3 anti-tank gun on the US M36 Gun Motor Carriage could penetrate at 50° at .

Development was halted with the end of the war: the 17-pdr was replaced by the 20-pdr for tank use, and by the 120 mm 'Battalion Anti Tank' recoilless rifle as an anti-tank artillery weapon. For infantry use it was intended to replace the 17-pdr with anti-tank guided missiles.

Ammunition

The ammunition was separate projectile and propelling charge. A number of projectiles were developed or planned including:

• H.E. Mk 1
• H.E. Mk 2
• H.E. Mk 3
• APCBC/T Mk1
• APCBC/T Mk2
• APCBC/T Mk3

The "T" indicated the shot had a tracer element to allow tracking it in flight.

Specification

• Calibre: 94 mm (3.7 in)
• Barrel length: 62.6 calibres,
• Chamber pressure
• Weight:
• Maximum effective range:
• Cartridge: 94×909mmR

See also

• British standard ordnance weights and measurements

References

• Allied Secret Weapons a Purnell's History of the World Wars Special. Phoebus, 1975, (No ISBN)
• https://search.worldcat.org/ja/title/1295166006