Anaconda Smelter Stack

From Wikipedia, the free encyclopedia
Jump to navigation Jump to search

Template:Short description Template:Use mdy dates Template:Infobox NRHP The Anaconda Smelter Stack is the tallest surviving masonry structure in the world, with an overall height of about Template:Convert, including a brick chimney Template:Convert tall and the downhill side of a concrete foundation Template:Convert tall.[1][2]Template:Efn-ua It is a brick smoke stack or chimney, built in 1918 as part of the Washoe Smelter of the Anaconda Copper Mining Company (ACM) at Anaconda, Montana, in the United States. A terra cotta coating covered the entire brick chimney when new, but by the time the smelter closed in 1981, most had eroded away except for the upper 40%, exposing most of its bricks and reinforcing rods. The inside diameter at the bottom of the brick chimney is Template:Convert while that at the top is about Template:Convert. The stack and its viewing area are now the two-part Anaconda Smoke Stack State Park.[3]

Dimensions

Brick chimney

The overall height of the stack is Template:Convert (≈ 585 feet),Template:Efn-ua including a brick chimney Template:Convert (≈ 555 feet) tall and the downhill side of a concrete foundation Template:Convert high. This was the height when new in 1918, but loss of the terra cotta that covered the top course of bricks since then reduced its height one or more inches. The lowest Template:Convert of the brick chimney is an octagon, the vertices of which point to the cardinal and intercardinal directions, north, northeast, east, etc., while its sides face the secondary-intercardinal directions, north-northeast, east-northeast, etc. Two large vertical openings are in the octagonal portion, each Template:Convert, on its east-southeast and south-southwest sides.[4] When operational, the main flue carried hot exhaust gases to these openings and then into the stack from the smelter which was on the north side of the hill upon which the stack rests.[5] The base of the octagon was Template:Convert (≈ 86 feet) side to side across its bottom before the loss of its terra cotta covering. But the inner surface of the octagon is circular with an inside diameter of Template:Convert (≈ 75 feet) across its bottom. The wall thickness of the octagon at its bottom ranges from Template:Convert (≈ 6 feet) at the center of a side to Template:Convert at each vertex. The rest of the chimney is a slightly tapering cylinder with a top inside diameter of Template:Convert (≈ 60 feet) and a wall thickness of Template:Convert (≈ 2 feet) just below a slightly flared top.[2] Its cylindrical portion plus the top Template:Convert of the octagon are encircled by many large steel rods (called bands) for reinforcement. It has had 20 lightning rods around its rim since it was built (which are not included in its height).[6][7] The stack contains 2,464,652 locally manufactured perforated tile bricks, each averaging 2.7 times larger by volume than the size of a normal brick.[6]Template:Efn-ua Most are radial bricks that are curved to match a sector of a cylindrical wall. The brick chimney weighs Template:Convert.[7]Template:Efn-ua

Concrete foundation

The lowest part of the stack is a concrete foundation or footing that is built on sloped ground with a grade of 21% (12°) because it is just below the top of a hill. It is Template:Convert high above ground at its downhill side and Template:Convert high above ground at its uphill side. It is a hollow octagon, Template:Convert side to side on top and Template:Convert side to side across its bottom, Template:Convert high on its downhill side and Template:Convert high on its uphill side, a third of the foundation being below ground. The stepped bottom of the foundation fits the stepped rock formation upon which it rests. The floor of the stack is generally conical leading Template:Convert down below the brick chimney to a Template:Convert rectangular grate, then into a Template:Convert square horizontal duct that exits the stack at the center of the downhill side of the foundation on its south-southeast side. This allowed any valuable metal dust particles left in the flue gases that precipitated down to that conical floor to be collected by a car on a track within the duct and sent back to the smelter for more processing.[2]

Construction

After the concrete foundation was completed in May 1918, construction of the stack began on May 23, 1918 and was completed on November 30, 1918. It was placed into operation on May 5, 1919.[6] It was built by the Alphons Custodis Chimney Construction Company of New York (now Hamon Custodis) under the direction of W. C. Capron, mechanical superintendent of the Washoe Smelting Company.[2][8] Much of the ore the smelter processed after 1955 came from the Berkeley Pit just north of Butte, Montana. At the time it was built, the stack was the tallest masonry, brickwork structure and chimney of any kind in the world and it remains the world's tallest surviving masonry structure.[1] Taller masonry chimneys have existed but have since been demolished. Taller chimneys that still exist are made of reinforced concrete. See List of tallest chimneys.

The Washington Monument would fit inside the stack's brick portion except for their lowest Template:Convert where an overlap of as much as Template:Convert at each corner of the monument would occur.Template:Efn-ua The stack's brick portion is about Template:Convert taller than the monument's 2015 height.Template:Efn-ua The masonry portion of the stack is about Template:Convert taller than the above ground portion of the monument's masonry, which disregards the monument's aluminum apex.[9]

The stack was designed to discharge exhaust gases from the various roasting and smelting furnaces at the smelter. The smelter had a large network of exhaust flues from the furnaces that all fed a main flue, which carried them a half-mile south up the hill to the stack.[5] The flue system and stack combined to provide a natural draft capable of carrying Template:Convert per minute of exhaust gases.[10]

State park

The Washoe Smelter was demolished after its closure in 1981. The stack alone, however, remains standing because the citizens of Anaconda organized to "Save the Stack." It is commonly referred to as "The Stack" or "The Big Stack"Template:Efn-ua and is a well-known landmark in western Montana. In 1986 it was designated the Anaconda Smoke Stack State Park.[11][3] The park has two parts: the Washoe Smelter Stack Viewing Center[12] constructed in 2000 just east of the town of Anaconda and the smoke stack about Template:Convert southeast of the viewing area. Although the site of the smelter underwent some environmental cleanup, the general public is not allowed access to the stack itself because the soil around it is still hazardous due to contamination by the toxic metalloid arsenic as well as copper, cadmium, lead and zinc.[13] Terra cotta covered the entire surface of the chimney just as it covered its top;[2] by the time of its closure, the bottom 60% had eroded, including the brick octagon, exposing its bricks and reinforcing rods. The terra cotta is now darker than the exposed bricks.

Template:Multiple image

See also

Notes

Template:Notelist-ua

References

Template:Reflist

External links

Template:Sister project

Template:S-achTemplate:S-endTemplate:CoordTemplate:Protected areas of MontanaTemplate:Authority control
Preceded byTemplate:S-bef/checkTemplate:Succession box/check World's tallest chimney
Template:Convert
1919–1937 Template:S-ttl/check 		Template:S-aft/check Succeeded by
  1. ↑ a b Script error: No such module "citation/CS1".
  2. ↑ a b c d e Script error: No such module "Citation/CS1". Provides precise dimensions via two drawings plus several rounded dimensions in its text.
  3. ↑ a b Script error: No such module "citation/CS1".
  4. ↑ National Register of Historic Places – Anaconda Copper Mining Company Smoke Stack. Three good photos.
  5. ↑ a b USGS topoView, → Get Maps → Search by location → Anaconda Montana → Anaconda, MT 1961.
  6. ↑ a b c Script error: No such module "citation/CS1". Blue box contains the words of a plaque entitled "Washoe Stack Facts" at the state park detailing its construction.
  7. ↑ a b Script error: No such module "Citation/CS1".
  8. ↑ Script error: No such module "citation/CS1".
  9. ↑ Cite error: Invalid <ref> tag; no text was provided for refs named letter
  10. ↑ Script error: No such module "citation/CS1".
  11. ↑ Script error: No such module "citation/CS1".
  12. ↑ Washoe Smelter Stack Viewing Site Monuments
  13. ↑ Superfund Site: Anaconda Co. Smelter, Anaconda, MT
Retrieved from "http://debianws.lexgopc.com/wiki143/index.php?title=Anaconda_Smelter_Stack&oldid=2228454"