Vampire tap: Difference between revisions
imported>ReadOnlyAccount sure, station was defined above, but to define somewhat more technical and obscure jargon up top and then proceed to use it in the article is probably too reminiscent of technical writing and not great prose for a general encyclopædia |
imported>Belbury added Category:Metaphors referring to monsters using HotCat |
||
| Line 20: | Line 20: | ||
[[Category:Ethernet cables]] | [[Category:Ethernet cables]] | ||
[[Category:Networking hardware]] | [[Category:Networking hardware]] | ||
[[Category:Metaphors referring to monsters]] | |||
{{compu-network-stub}} | {{compu-network-stub}} | ||
{{compu-hardware-stub}} | {{compu-hardware-stub}} | ||
Latest revision as of 14:50, 19 September 2025
A vampire tap (also called a piercing tap) is a device for physically connecting a station, typically a computer, to a network that used 10BASE5 cabling. This device clamped onto and "bit" into the cable[1] (hence the name "vampire"), inserting a probe through a hole drilled using a special tool through the outer shielding to contact the inner conductor, while other spikes bit into the outer conductor.
The vampire tap usually had an integrated AUI (Attachment Unit Interface) in the form of a DA-15 connector, from which a short multicore cable connected to the network card in the station (host computer).
Vampire taps allowed new connections to be made on a given physical cable while the cable was in use. This allowed administrators to expand bus topology network sections without interrupting communications. Without a vampire tap, the cable had to be cut and connectors had to be attached to both ends.[2]
See also
References
- REDIRECT Template:Reflist